EGW VORTEX VIPER / VENOM RUGER AUTO (MK 1, MK 2, MK 3, MK 4, P85, P90-95, 97) SIGHT MOUNT (FITS BURRIS FASTFIRE, DOCTER, VIRIDIAN RFX25) 49321

Mounting Hardware is Included

This is a press fit mount. Utilization of a sight pusher tool may be required.

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.

This mount fits:

• Ruger MK I (Ruger Mark I)
• Ruger MK II (Ruger Mark II)
• Ruger MK III (Ruger Mark III)
• Ruger MK IV (Ruger Mark IV)
• Ruger P85
• Ruger P90-95
• Ruger P97
• Ruger 22/45

This mount doesn't fit:

• Ruger P89

Material: 7075 Aluminum

Coating: Matte Black Hardcoat

Overall Length: 1.811"

Overall Width: .99"

Mounting Hardware: (2) 6-32 Button Head Screws, (2) 6-32 Flat Head Screws, (2) 6-32 Set Screw

Red Dot Fitment:

• Viridian RFX25
• Vortex Viper
• Vortex Venom
• Burris FastFire
• Burris FastFire 2
• Burris FastFire 3
• Burris FastFire 4
• Docter
• ADE RD3-001
• ADE RD3-002
• ADE RD3-009
• UTG Reflex Micro Dot
• Crimson Trace CTS-1200
• Crimson Trace CTS-1300
• Sightmark Mini Shot
• Cuda RX-795

Red Dot Fitment:

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions

- Remove the rear sight*

- Install the EGW Sight Mount in the dovetail

- Tighten set screw (if applicable)

- Place the red dot sight on the EGW Sight Mount

(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)

- Apply blue Loctite to the provided mounting screws

- Torque mounting screws to 15in/lbs

2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights

2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Modification of your firearm may nullify the manufacturer's warranty.

This product should be installed and checked by a qualified gunsmith.

No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.